LESSON 19
- “干涉”怎么说?
- “运转”怎么说?
- welcome购彩大厅用户注册 :“工序切换”怎么说?
- 冷却水流量下降造成装置故障!
- welcome购彩大厅用户注册 :如何防止过滤装置堵塞?
- “波形”怎么说?
- 有关建议的表达方法
- “加工”怎么说?
- “配线”怎么说?
- 有关电气破坏
“配线”用英语怎么说?
“配线”在英语英语中称之为wiring。
![面露难色的王工](/Images/n11_11_01_2102145.gif)
- I'm considering how to do the wiring for the new detection system. When this sensor X and this sensor Y are both turned on I want it to make the system stop, but how do you think I should wire it?
- 我在研究新检测装置的配线。我想在这里的X传感器和Y传感器同时为ON的时候让装置停止,该怎么配线呢?
![Cindy](/Images/n11_06_01_2102140.gif)
- If that's what you are doing, a series wiring would work.
By the way, what is the purpose of putting in these sensors? - 那样的话,采用串联配线就可以了。
你安装这些传感器的目的是什么呢?
![王工](/Images/n11_02_01_2102136.gif)
- I'm putting them in to ensure safety. Is there anything else I should be careful of when I do the wiring?
- 是为了确保安全才安装的。
在配线时,还有其它需要注意的地方吗?
![Cindy](/Images/n11_06_01_2102140.gif)
- If you are using them as a safety device, Normal Close should be used for the wiring so that a signal is sent when the sensor is off, not on. Otherwise, if the sensor is broken there is a chance that a signal might be sent from Normal Open and cause a safety problem.
- 如果是作为安全对策,就必须在传感器为OFF而非ON时发出信号的B接点处进行配线。否则,如果使用A接点,那么在传感器损坏时也会发出信号,引起安全问题。